mov ax, 0x0405 ; unpacked 45 (AH=04, AL=05) add al, 0x03 ; add unpacked 3 → AL=08 aaa ; adjusts if AL>9, increments AH The 6502 has no dedicated BCD arithmetic instructions, but it includes a Decimal Mode flag (D flag in status register). When set, all ADC and SBC instructions automatically perform BCD arithmetic.
| Command | Effect in Decimal Mode | |---------|------------------------| | | Set Decimal Mode (D=1) | | CLD | Clear Decimal Mode (D=0, back to binary) | | ADC | Adds with carry in BCD | | SBC | Subtracts with borrow in BCD | bcd commands
mov al, 0x45 ; BCD 45 add al, 0x27 ; BCD 27 → binary result 0x6C daa ; adjusts to 0x72 (BCD 72) mov ax, 0x0405 ; unpacked 45 (AH=04, AL=05)
mov ax, dx shr ax, 8 ; high byte of BCD1 mov dx, bx shr dx, 8 ; high byte of BCD2 add al, dl daa mov dl, al mov al, ah adc al, dh daa mov dh, al ld a, $45 add a, $27 daa ;
uint8_t bcd_add(uint8_t a, uint8_t b) uint16_t sum = (a & 0x0F) + (b & 0x0F) + (((a >> 4) + (b >> 4)) << 4); if ((sum & 0x0F) >= 10) sum += 6; if ((sum >> 4) >= 10) sum += 0x60; return (uint8_t)sum;
The 8051 has a DA (Decimal Adjust) instruction that operates on the accumulator after addition.
ld a, $45 add a, $27 daa ; A becomes $72 The Z80 DAA uses carry and half-carry flags to correct the accumulator. ARM (especially Thumb and Cortex-M) does not have dedicated BCD arithmetic instructions. BCD operations must be implemented via software routines, using bit manipulation and conditional addition/subtraction.